AEM shortram install
#1
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: naples, fl
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
AEM shortram install
ok i got a few questions, first what do i do with the hose that runs to the stock rubber pipe that is connected to the inside of it, the rubber piece that is connected to the maf. do i just rip it off? also there is a smaller opening on the aem tube, what goes there? thanks help needed fast. i searched alot and didnt come up with anything.
#3
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: naples, fl
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
well i installed the hard pipe, and on the hard pipe there is a small nipple, big nipple and a hole on the bottem. now on the stock rubber intake the small nipple connected to a hose, now do i have to reconnect that? there is also a hose that goes to the bottem hole, do i connect that too? thanks, also is the aem shortram ok for the o5 evos, and i have a greddy type s and it prematurallys opens and i switched out the diaphram but it still makes a loud flutter at part throttle and i lose alot of boost. what do you guys think the problem is? the flange?
#6
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: naples, fl
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by WHTEVO
Kyle, i am giving you a call right now to help you out again.
Aaron
Aaron
#7
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: naples, fl
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by EVO316
I don't think you searched hard enough. There is a sticky on this in the HOW TO section, explains the whole install, just have to LOOK.
Thread
Thread Starter
Forum
Replies
Last Post
rogue
Evo X Engine Management / Tuning Forums
15
Oct 31, 2009 11:27 PM
LancerOZ
Lancer Troubleshooting
5
Oct 21, 2004 05:27 PM