HID low beam out... replaced bulb/fuse.. still out
#16
Evolving Member
iTrader: (28)
Join Date: Feb 2004
Location: Greencastle, PA
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Can you give me an update? I unfortunately followed your path by buying the bulbs (waited for my IC pipes to arrive) and swapped them out this weekend. No joy. Swapped bulbs side to side and housings side to side. Have voltage to module also. Where did you end up getting your module at?
Thanks
Thanks
#17
Evolved Member
Originally Posted by GranMassaX
ok, so i checked the plug going into the ballast and that had power. So I decided to check to make sure I didn't get a "dead" bulb. I connected everything and then checke what I think are the correct terminals for the HID bulb itself and bingo, no power. So it has to be the ballast. Power into ballast is good, but no power out.
these are the two terminals I checked, are these the right ones? There are other metal clips, but they look like they are just there to secure the bulb in place.
these are the two terminals I checked, are these the right ones? There are other metal clips, but they look like they are just there to secure the bulb in place.
#18
Evolving Member
Thread Starter
iTrader: (11)
Join Date: Jul 2003
Location: Albany, NY
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by evojon
Can you give me an update? I unfortunately followed your path by buying the bulbs (waited for my IC pipes to arrive) and swapped them out this weekend. No joy. Swapped bulbs side to side and housings side to side. Have voltage to module also. Where did you end up getting your module at?
Thanks
Thanks
good luck and let me know how you make out.
Thread
Thread Starter
Forum
Replies
Last Post