Just got my GSC cams and please take a look.. (pics)
#1
Evolving Member
Thread Starter
iTrader: (2)
Join Date: May 2005
Location: Aurora, IL
Posts: 365
Likes: 0
Received 0 Likes
on
0 Posts
Just got my GSC cams and please take a look.. (pics)
the lopes(?) are not really even... is this ok? should i install them?
this kinda concerns me...
this kinda concerns me...
Last edited by fq340; Aug 9, 2006 at 08:51 PM.
Trending Topics
#8
Evolving Member
They don't have a real high quality look to them. But I bet they would work just fine. Look at your stock cams, you can see the wear marks from the rockers in them. Theres a good 1/8" of lobe left on each side that dosn't touch the rocker. The rough dges on your new cam would be well in the no contact area. If you put them in just turn them over by hand first and make sure.
#12
Evolving Member
Thread Starter
iTrader: (2)
Join Date: May 2005
Location: Aurora, IL
Posts: 365
Likes: 0
Received 0 Likes
on
0 Posts
well i think it will work fine but i'm just worring about the "sharp corner" coming off after a while of use.. and if that little piece remains in the engine... i'll call GSC and see what they think... anyone has similar problem?