03nmeva

iTrader: (2)

Ok so i have a boost leak thats coming from my throttle body and my blow off valve and im gonna replace the shaft seals. So my question is which shaft seals should i use? The Mil.Spec ones or the Works ones? im not sure which ones to go with so let me kno

Q8_EVO

iTrader: (67)

Mil Spec

mrboost05

iTrader: (25)

ive used the mil spec and they worked well so far he has a vendor thread somewhere on here he ships fast and will even send a throttle body gasket if you want.

Kracka

iTrader: (49)

Mil.Spec; get a new TB gasket too as mentioned above.

Domolution

iTrader: (74)

+1

FQ-300

iTrader: (17)

Mil Spec

lemmysports2

iTrader: (27)

im sure there both basically the same.. i have the works, they went in easily and ive had no problems with them

mifesto

iTrader: (58)

sorry if this is slightly off-topic but i'm sure i'm not the only one who wants to know.... the install walkthrough i believe said to lub the TB seals when you push them back in.... any recommendations on the lub?

xtnct

iTrader: (33)

I put the Works ones in about 2 years ago.

Foolproof

Just ordered the Mil.Spec. Stockers are leaking bad

MR Turco

iTrader: (16)

Mil.spec. I have installed dozens of these.

BoostWhore

iTrader: (42)

Search theres a DIY on how to do it. As for lube just put some synthetic grease nothing special.

lemmysports2

iTrader: (27)

i used a small amount of lithium grease on the outside of the seals to help them slide into place and on the tb shaft itself cause its a moving part

MR Turco

iTrader: (16)

i use dielectric grease

churbo

iTrader: (2)

I used dielectric grease as well. I went with the WORKS seals. I have one seal because i f'ed on of them up and had to buy another set. I got mine for 20 shipped.....I can hook you up if you pm me