Another problem!!
#1
Newbie
Thread Starter
iTrader: (8)
Join Date: Jun 2009
Location: Somewhere in CT
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Another problem!!
For some reason my car is idling about 200 rpms lower, and it doesn't usually want to start, when you start the car, the rpm's immediately fall down to around 500-600, and with the cams, it struggles to keep running. Sometimes it just plain shuts off. This started happening the day after I filled my tank and fixed all the boost leaks on my intake. Does anyone know what the problem could be?! The low rps idle is too rough... Could i have anything to do with being tuned with a boost leak?
#4
Evolving Member
iTrader: (12)
Join Date: Jul 2009
Location: LI NY
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
For some reason my car is idling about 200 rpms lower, and it doesn't usually want to start, when you start the car, the rpm's immediately fall down to around 500-600, and with the cams, it struggles to keep running. Sometimes it just plain shuts off. This started happening the day after I filled my tank and fixed all the boost leaks on my intake. Does anyone know what the problem could be?! The low rps idle is too rough... Could i have anything to do with being tuned with a boost leak?
Trending Topics
#12
Newbie
Thread Starter
iTrader: (8)
Join Date: Jun 2009
Location: Somewhere in CT
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
I'm gonna try the battery cable method, cause everything else checks out. I notice a cable that I had notice wasn't grounded when I had fixed the vacuum leaks and I can grounded it properly. Well, when ever I play with that, the problems get worse. Not when I first start moving the car, it want idle surge, hard... Until I let the car set and surge for a good 2-3 minutes, then it settles around 1800rpm and slowly over time lowers to 1100, which is where it needs to be. He's a pic of the cable, if you guys can identify it.
![](http://i17.photobucket.com/albums/b54/attentionnexus/b4006455.jpg)
It's between the fuse box and the master cylinder.
![](http://i17.photobucket.com/albums/b54/attentionnexus/b4006455.jpg)
It's between the fuse box and the master cylinder.
#15
Newbie
Thread Starter
iTrader: (8)
Join Date: Jun 2009
Location: Somewhere in CT
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Guys! Problem is still there, just getting worse. It just wants to idle at 2k, then pulse from 1600 to 2200 rpm for a minute, then back to 2k. I've notice that it seems to stop when I get the car above 10mph and stop the car with the handbrake. I realize it sounds stupid, but it's not a lie. Also, is nobody able to identify that wire. I've tried every suggestion, I'm tired of the poor drivability and wasted gas.