I am going to be installing a TBE from AMS and I wanted to know if there are any torque specs for the 14mm spring bolts connecting the DP to the O2 sensor housing and the two lower control arm braces that need to be removed to install the new DP. I have already looked through "the evolution torque specs thread" didnt see what I was looking for. Thanks for the help.

 

*** edit ***


DP to o2 housing should be 37 ft lbs according to mitsu, but i always use german torque specs. and just tighten the braces back up, i wouldn't worry about torque specs on those.