JDM HVAC control
Feb 6, 2014, 07:55 AM
#61
I'm guessing you mean the brown one with the black cap over the end of it? I have no idea where it mounted, just that it was in the engine bay somewhere 
And the connector is just .... some 2-pin connector that goes to the sensor. the other end is just the two wires that aren't attached to anything yet
And the connector is just .... some 2-pin connector that goes to the sensor. the other end is just the two wires that aren't attached to anything yet
Feb 11, 2014, 01:24 PM
#63
yup - looks the same as the one I have!
Good news; the guy who I'm buying parts from emailed me back and is home from vacation so I'm getting a few more things on my list wrapped up to send to him and see if he has them.
Needing the heater water temp sensor, sunlight sensor trim piece (i have the sensor though), blower motor connector and then it's time to wire!
I have a 240 that will be getting a new motor soon (at the machine shop now) so once that's up and driving I'll be able to tear apart the evo for a bit and mess around with this!
Good news; the guy who I'm buying parts from emailed me back and is home from vacation so I'm getting a few more things on my list wrapped up to send to him and see if he has them.
Needing the heater water temp sensor, sunlight sensor trim piece (i have the sensor though), blower motor connector and then it's time to wire!
I have a 240 that will be getting a new motor soon (at the machine shop now) so once that's up and driving I'll be able to tear apart the evo for a bit and mess around with this!
Thread
Thread Starter
Forum
Replies
Last Post
