Well, I went into MAC autosport's today to get my car dyno'd and tuned. My first pull without any adjustment was 335 WHP 342 Torque. My last pull of the day I ended up at 372 WHP and 366 Torque which I found quite amazing. especially since we still have quite a bit to do with the A/F and we haven't even started on the timing. I'll post slip's as soon as I get em scanned.

 

what boost where you running?

 

21 in 3rd

 

Might i humbly ask... how much did all your mods cost?

 

A slip would be awesome....way to go man!!! Nice numbers!!!

 

What mods are you running? Stock turbo or a turbo kit? What octane gas? Those are some good numbers so I would just like to know how you are getting them. Thanks

 

Read his sig. 264 cams and BR FMIC is what did it.

 

Nice numbers, but next time make some 4th gear pulls so you can find out the actual numbers, not just inflated ones

 

I saw that, but those numbers are very good for that few mods. I was really curios to see if it was on 93 or not. Very good number off of the stock turbo though if it is on 93. And what gear is a good question as well.

 

nice i'm putting in 272's this weekend. and i have pretty much the same mods as you excpet i don't have a downpipe nor a aftermarket intercooler

 

Awesome numbers bro, I getting my cams soon along with injectors . Cant wait!!!!! How is your powerband with that power? and also was this with pump or race gas.

 

Exactly!

 

Those numbers seem high for your mods. What type of Dyno was it if you dont mind me asking?

 

Great Numbers!! I'll be there Fri. to tune my AFC II,w/Mods. Have all Buschur's Mods except Cams. Can't wait to see what it will do. -The dyno is a DynoJet. Nice setup. The guys down at Mac are awsome at what they do! -4th Gear pulls show about the same numbers. Did see one Evo that had more torque in 4th, thats all.-

 

It is on a DynoJet Dyno, I went back today got my car tuned a little more, and pulled a 398 WHP 383 Torque out of it. this is on 91 octane gas, no octane booster, no race gas. The pulls were made in 3rd gear. I'm hopefully going back tomorrow to make some 4th gear pulls and up my boost a little more I will post results when I get them. I will try to find someone with a scanner so I can put up the dyno sheet's.