gearbox really hard and reverse wont engage
#1
Evolving Member
Thread Starter
gearbox really hard and reverse wont engage
Have a twin plate with less than 200 miles.
Slave went on saturday replaced it along with master used cheap liquid im not in the usa.
I have to double clutch to engage gears. Reverse is really hard. Car was fine before.
Slave went on saturday replaced it along with master used cheap liquid im not in the usa.
I have to double clutch to engage gears. Reverse is really hard. Car was fine before.
Trending Topics
#9
Evolving Member
iTrader: (18)
I had the same problem with an Exedy Twin. Tried all kinds of different jazz (rebleeding, new slave/master cylinder, SS clutch line, adjusting pedal). It only had a couple of hundred miles on it when it started, too.
I ended up just having to cope with it by pushing the clutch in, shifting 3rd gear and then quickly to Reverse. Sometimes 1st gear would be tough, too, so I would use the same procedure rather than forcing it into gear. After awhile, it was second nature.
Now I have a different twin plate and it doesn't have any problems like the Exedy.
I ended up just having to cope with it by pushing the clutch in, shifting 3rd gear and then quickly to Reverse. Sometimes 1st gear would be tough, too, so I would use the same procedure rather than forcing it into gear. After awhile, it was second nature.
Now I have a different twin plate and it doesn't have any problems like the Exedy.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainSquirts
Evo Engine / Turbo / Drivetrain
3
May 17, 2016 08:35 PM
Rumblefish237
04-06 Ralliart Engine/Drivetrain
16
Sep 1, 2011 02:26 PM