Camrymatic

iTrader: (16)

If you were putting together the essential EVO toolbox, what would you have?

I will start:

8,10,12,14 Sockets- most of the car comes apart with these.

Kian

Duct tape, pliers, and a can of WD-40

twabtoxer

iTrader: (39)

Zip ties!!!!

Pal215

iTrader: (12)

Great Idea OP!

1. 1/2 Inch Breaker Bar,
2. C- Clamps,
3. Soldering Iron for Electronic repairs or installs.
4. Jack
5. Jack Stands
6. Some *****

-Pal215

EvoJoeIX

iTrader: (16)

Timing belt tensioner tool
Brake caliper piston spreader
Valve spring tool
Oil filter socket type wrench

gsrboi80

iTrader: (38)

Jays Racing timing tools, bolt welded on slide hammer to pull shaft when doing a clutch, Home Depot made boost leak tester, and a Harbor Freight fluid pump for TC and rear diff

Oh EVOSCAN and ECUFlash also

Can't live without em

LancerSRT4

Out of everything listed here, THATS the most expensive and useless.

How about a stress ball?
oh, and boxing gloves. (because if someone distracts you from your work...you're gonna hit em.)

ray3328

iTrader: (37)

A good compaction gun, torque wrench, jack and stands, good socket set, zip ties, spark plug socket

evotuner04

iTrader: (45)

Aaa (towing)

Viegasjuice

iTrader: (1)

Lmao

Thore

iTrader: (27)

I thought it was funny too, until I realized he was serious.

Most used tool for me was a 10mm and/or 12mm deep socket.

Torque wrench, jack stands and a jack will make life a lot easier.

jager89

iTrader: (1)

32mm socket!

evo_yoshi15

Pretty Much $ Lol

blowngasket

iTrader: (4)

the damn clutch alignment tool, i always seem to lose lol

10,12,14,17 MM everything

Large sockets to put seals in

And if you get into stuff like i do, drive train rebuilds and such


Press, Brass Drift, and a bearing Race puller that i made from a old pair of Channel locks using one handle of them and grinding it down.

evotuner04

iTrader: (45)

I've actually never needed mine towed haha, but a lot of evo buddies sure have