Cylinder head not getting oil??
#1
Cylinder head not getting oil??
Alright everyone, I just got my cylinder head back from the machine shop to have a couple of bent valves replaced from my timing belt failure. However now with a new headgasket, everything torqued properly, the head isn't getting oil? Oil pressure was fine, everything timed properly. What are some probable causes of this??
#2
Evolving Member
iTrader: (1)
not sure but did you flip the head gasket around where it may have covered holes it want supposed to? I know this is what happend to me on my subie when I did gaskets, but was very obvious once i flipped it around and saw coolant passages sticking outside of the sealing surfaces between the head and block.
Thread
Thread Starter
Forum
Replies
Last Post
J8dailo
Evo Engine / Turbo / Drivetrain
4
Oct 29, 2012 05:39 AM
jimib
Evo Engine / Turbo / Drivetrain
98
Jul 15, 2009 03:28 PM