Transfer case removal questions...
#1
Evolving Member
Thread Starter
iTrader: (16)
Join Date: Mar 2003
Location: Blue Grass, Iowa
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
Transfer case removal questions...
Posted a few questions in the Transfer Case removal How-To thread but didn't get any replies, so I'm posting a new one. Hope that's ok.
I have it almost all the way out. The transfer case slid 2 or 3 inches out on the shaft, and it seems to be stuck at that point. I can slide it back towards the tranny, then out again, and it always stops at the same point. Any thoughts??
Thanks
I have it almost all the way out. The transfer case slid 2 or 3 inches out on the shaft, and it seems to be stuck at that point. I can slide it back towards the tranny, then out again, and it always stops at the same point. Any thoughts??
Thanks
#5
Evolving Member
Thread Starter
iTrader: (16)
Join Date: Mar 2003
Location: Blue Grass, Iowa
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
Yeah that's not the problem - when I'm sliding the TC off the trans, it's stopping before it's all the way off. I can feel all the way around the TC it's not hitting anything.
Trending Topics
#10
Evolving Member
Thread Starter
iTrader: (16)
Join Date: Mar 2003
Location: Blue Grass, Iowa
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
Cool. Unfortunately I don't have a slide hammer yet (I thought i could take the shaft out once the Tcase was out). I have a long bar with a hole in the middle, threaded the bolt through the bar into the shaft and have been trying to get it out that way, but not much luck.... Guess I'll have to make a store run for a slide hammer after my new Tcase shows up.