Please help.
I followed this walkthrough for my injector install
http://www.evotuners.net/forums/f20/...injectors-427/

My tuner has the map in for my injectors and I already loaded it onto car.

Mods:
GSC s2 cams supertech valves/springs/retainers
Walbro
FIC 1450 blumemax
stock evo 9 turbo
stock bottom end
intake
ets 3.5" fmic

3/4 full tank of gas.

Car cranks and almost fires, but never will.
EDIT: Car also has been on a charger for 4 hours and doesnt get much past 11.8v, once i try to crank her over it falls to 9.8ish.
Thanks,
Jeff

 

probably a bad starter...check the voltage that ur getting on ur starter

 

I have the car jumped right now, car is very close to turning over, smoking is coming out of the exhaust. I'm going to try to push start it and see if the starter is dead.

 

Just had starter tested and its dead. It wasnt dead 3 days ago... Getting a replacement tomorrow, let hope this solves it.

Are there any fuses missing here?
https://www.evolutionm.net/forums/9510971-post40.html

I found this thread and it shows the relay to be in the empty slot on my car. However my car started fine 4 days ago. Please help.
https://www.evolutionm.net/forums/4913702-post3.html

 

I did nothing wrong, all that needed to be adjusted were the latency values and it fired right up..... I used the receommended ones on the thread.

 

The rom on there somehow was corrupt. Problem solves. Mods can close this thread.