David Buschur

iTrader: (53)

Our standard 2.3 will run 9.70's no problem, you are going to need a taller tire that hooks anyway, so a 26" slick/DOT will keep the RPM's low enough to get by or go to a 4.11 final drive. Then there is our 2.3RPM engine option which we ran to 9900 numerous times this weekend.

KTriplett

iTrader: (20)

As always thanks Dave. Ill be putting some serious thought into the 2.3. Im at the point now where all I need is a motor. Im sure whatever Buschur motor I get will make power with the stm650 cams and a 6262 I think my goals should be reachable especially with one of your motors.

tsidrift1

iTrader: (46)

Can that 2.0 be drilled for mivec?

David Buschur

iTrader: (53)

If you are going to use STM650's and a 6262 then get the aluminum rod 2.1 I have listed or a 2 liter, don't waste your time with the 2.3 engine, you aren't looking for low end anyway.

Yes, the 2.0 can be made to work with MIVEC.

KTriplett

iTrader: (20)

Thanks Dave.Let me see what I can do to get that engine. I shouldnt have any problems staying on stock ecu. I hope to eventually move to the aem's.

silver9mr

iTrader: (8)

so your saying the aluminum rods will not last as long?

Im in the market for a new motor since iv spun a bearing 2 months ago and im just looking for my best option.