Possible New EVO 9 Carbon Lip From APR!!
#31
Originally Posted by Turbolover
too sharp of edges
#32
Originally Posted by Turbolover
too sharp of edges
#33
Thread Starter
Former Sponsor
iTrader: (98)
Joined: Feb 2003
Posts: 4,260
Likes: 2
From: Gilbert, AZ
Pricing Update!! https://www.evolutionm.net/forums/sh...d.php?t=188406
#35
Originally Posted by meanmud
Removing the bumper - 5/10 minutes
Taking off the lower lip - 5 minutes
Installing new lip - 10/15 minutes; fitment is not usually "Dead-On", don't know about THIS one.
Putting bumper on - 10 minutes.
Very easy - look in the "How To" section for the bumper removal - Difficulty level from 1 to 5 = 1
Taking off the lower lip - 5 minutes
Installing new lip - 10/15 minutes; fitment is not usually "Dead-On", don't know about THIS one.
Putting bumper on - 10 minutes.
Very easy - look in the "How To" section for the bumper removal - Difficulty level from 1 to 5 = 1
#36
i am in no way affiliated with Vivid but to be honest, the fitment is perfect. Every single screw fit perfect, none of the holes for the factory screws were mis-aligned. And I also watched another one get installed shortly after with the same results.
On a side note, I am not too into front lips and such however, everyone else seems to be out in town, everyone that has commented on my car in person says the front lip is very clean looking.
I can say that this lip has withstood a little abuse from steep driveways, I noticed a couple of rock chips and was upset but after hitting a little pavement and seeing that it withstood it pretty well, I am a satisfied customer.
EDIT - we did not have to remove the bumper either for installation, just threw the car on a lift and went to work.
On a side note, I am not too into front lips and such however, everyone else seems to be out in town, everyone that has commented on my car in person says the front lip is very clean looking.
I can say that this lip has withstood a little abuse from steep driveways, I noticed a couple of rock chips and was upset but after hitting a little pavement and seeing that it withstood it pretty well, I am a satisfied customer.
EDIT - we did not have to remove the bumper either for installation, just threw the car on a lift and went to work.
Thread
Thread Starter
Forum
Replies
Last Post