We are now offering a 100% bolt on Turbo kit w/ Front Facing Turbo Manifold.. After seeing a constant demand week after week for a turbo kit with a front facing turbo like we ran 8's with on our RS, we have decided to offer the Full kit now.. This kit will Include the below items.. Starting Pricing will be at 3995.00 but will depend on Choice of Turbo.. We will also offer the kit as a hot parts kit with Manifold, 02 Housing, Downpipe and Dumptube..

T3 Front Facing Shearer Manifold

T3 Turbo of choice.. ( We Recommend PTE Billet 6262 for most Setups )

Tial 44mm Wastgate

4 Bolt 02 Housing

Dump tube

3" downpipe

Lines, Fittings and Gaskets

Below are some pics of the Manifold and Turbos.. I will update this thread as we put the kit together on our Shop Evo.. If you have any questions dont hesitate to ask!! Thanks!!

 

does it come with an air filter?

 

Sorry i should have posted a pic of where it actually places the turbo.. It doesnt leave room for filter.. You can put a screen over it and a plate in front grill best case scenario.. This kit is more for the hardcore racer..

 

bump for an awesome kit.

 

ttt

 

How much for a 6262 and are they 5 bolt?

 

def not 4 the street

 

What's the difference between this and the BR kit? Both manifold are made by Shearer; is there a difference in design? Are v-clamp housings/parts vice bolt available?

 

PM for pricing and they can come 4bolt or 5 bolt..

MIke

 

BR kit was designed to fit a Filter on front. The kit above is much more forward and will not fit a filter on it.. You can use a screen and Block off the front grille if you need to street drive it.. This isnt recommended for a daily driver... More of a race setup than anything,,

MIke

 

Thanks for that explanation Mike. I think what consumers like myself need to know is what performance advantages one kit provides over the other. I would assume that the runner length is longer on your kit than BR's seeing as how it is farther forward. Does this result in more horsepower but less torque (with all other factors remaining the same)?

I would consider the two kits to be an apples to apples comparison and therefore need to understand performance differences between the two. Thanks!

 

I would say the kits are very comparable. I would guess BR design is a longer runner manifold regardless of it not being as close to the front of the car as my kit is. I can't compare kits as these manifolds have never been tested back to back.

The main difference is my kit does not allow a filter. Both are proven to make sick up and run fast. Comes down to if you need a filter of not and which design you prefer. Both are top notch shearer quality.

Mike

 

got any pictures of the engine bay on how will it look like?

 

https://www.evolutionm.net/forums/ev...-gsr-back.html

 

ttt