NEW ITEM !! CARON D-FORCE add-on Spoiler ( Vortex Generator ) !!!
#22
Evolved Member
iTrader: (23)
Join Date: Jun 2004
Location: Orlando FL
Posts: 1,240
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Late Apex
looks nice but i think if it filled up the whole wing it would be nicer. seems out of place right in the middle
I'd buy one for sure if it filled up the entire width of the spoiler!
Also, if it used the same 1x1 weave as the OEM spoiler instead of the larger 2x2 weave, it would match better!
Last edited by Mike@Forge; Oct 7, 2005 at 02:46 PM.
#23
Evolved Member
For best aero results it should run right to the edges of the wing end fences and is way too tall. It would still be overkill being as tall as the end fences on the wing eventhough that would look best aesthically. If you made it as tall as the carbon goes up on the end fences and 90 degrees to the ground like a gurney flap I'd buy one.
#25
Originally Posted by Mike@Forge
+1
I'd buy one for sure if it filled up the entire width of the spoiler!
Also, if it used the same 1x1 weave as the OEM spoiler instead of the larger 2x2 weave, it would match better!
I'd buy one for sure if it filled up the entire width of the spoiler!
Also, if it used the same 1x1 weave as the OEM spoiler instead of the larger 2x2 weave, it would match better!
#27
Evolving Member
iTrader: (6)
Join Date: Nov 2003
Location: Monroe, wa
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Good idea, just it needs to fill the length of the wing and be a bit shorter (looks like some stick-on add-on from JCWhitney)
Also the weave needs to be the same as the spoiler (looks out of place with different weave)
Also the weave needs to be the same as the spoiler (looks out of place with different weave)
Thread
Thread Starter
Forum
Replies
Last Post
FS[Mid-Atlantic]: Evo 8 Garage clean out. HKS, AEM, FORGE...
Sp00linEvo8
For Sale/WTB - Engine / Drivetrain / Power
2
Jun 8, 2016 07:32 AM
EVO-8-Silver
Evo Show / Shine
45
Sep 8, 2006 10:25 AM
EVO-8-Silver
Evo Show / Shine
27
Oct 14, 2005 04:21 PM