The Ultimate Aggressive Wheel Thread...
May 23, 2008, 10:54 AM
#2071
I am lowered on Swift Spec-R springs. There is a slight rubbing in the rear over sharp bumps or dips. Kinda having to drive it very carefully right now.
I will be doing a half roll job and see if it will be good enough. I want to avoid doing a full roll because I don't want to dent the quarters. If the half roll doesn't work I will be taking the lip off with a cutting wheel and leaving 3mm or so that I can roll upward.
I will be doing a half roll job and see if it will be good enough. I want to avoid doing a full roll because I don't want to dent the quarters. If the half roll doesn't work I will be taking the lip off with a cutting wheel and leaving 3mm or so that I can roll upward.
May 25, 2008, 11:13 PM
#2077
Evolving Member
iTrader: (11)
Join Date: Oct 2005
Location: Fort Campbell
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
5Zigen ZR+520 18x9.5 275/40/18 Falkin FK-452 I recommond not to go this route unless you are willing to put the time to cut pieces of metal out of the car.
Last edited by Kevindanger; May 25, 2008 at 11:26 PM.
May 26, 2008, 02:10 AM
#2080
Evolving Member
iTrader: (11)
Join Date: Oct 2005
Location: Fort Campbell
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
At this point the offset didn't matter but is it 37 the tire rub through the plastic piece in the back of the front fenders. And cutting deep into the tire on bare metal. Had to dremal and sand that piece close the front side marker. Also rolled the rear fenders
May 30, 2008, 09:03 PM
#2082
Evolving Member
iTrader: (1)
Join Date: Jun 2006
Location: Mountain Country, Utah
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
+28 BUMP
What are you +28's running for rear camber? I just put it on for a test fit. Need to roll the rears for sure, but not sure if I need some more camber or not.
+12 BUMP
Trying to buy these from my friend and get a smaller tires.
What are you +28's running for rear camber? I just put it on for a test fit. Need to roll the rears for sure, but not sure if I need some more camber or not.
+12 BUMP
Trying to buy these from my friend and get a smaller tires.
May 31, 2008, 09:25 AM
#2083
Evolved Member
iTrader: (22)
Join Date: Jan 2006
Location: Kissimmee, Fl
Posts: 1,438
Likes: 0
Received 0 Likes
on
0 Posts
^Wow! I absolutely love those bronze wheels 
.
I remember that I've seen it before on another car, but I forgot who made these or what are these called. Could someone tell me what's the name for these wheels?
.I remember that I've seen it before on another car, but I forgot who made these or what are these called. Could someone tell me what's the name for these wheels?
May 31, 2008, 02:50 PM
#2085
Evolved Member
iTrader: (22)
Join Date: Jan 2006
Location: Kissimmee, Fl
Posts: 1,438
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, my friend which is a member here (Evo Tengoku) told me the same thing. Too bad it's discontinued (where replaced with the RE30), but there may be some left in the U.S.