Mitchubishi: Lots of parts installed...finally! 56K unapproved
#17
Evolving Member
iTrader: (23)
Join Date: Jun 2004
Location: OK/TX
Posts: 341
Likes: 0
Received 0 Likes
on
0 Posts
Very nice, I have the manifold and O2 housing from PPI and they are great parts. On my O2 housing I had to enlarge one of the bolt holes on the O2 housing where it mates with the hot side to get it to assemble together so you should be on the look out for that. Good luck on your build!
#19
Very nice, I have the manifold and O2 housing from PPI and they are great parts. On my O2 housing I had to enlarge one of the bolt holes on the O2 housing where it mates with the hot side to get it to assemble together so you should be on the look out for that. Good luck on your build!
Car pulls HARD even untuned! I'm going to get some dyno time and show that these ported coated peices really do the work, amkign everything more efficient.
Big thanks go out to my friend for the install.
#27
Update, the A-Spec Ti Test Pipe does not fit perfectly....makes the mid pipe rattle against a bracket which will eventually cause a hole in the pipe. My friend/installer suggested using some wire hangers to pull the exhaust to the right and allow ot to sit without contact...I hate the ghetto rig but we shall see tomorrow if it works.
So far, the car is still not tuned and has a funky boost controller in place of the EVC 6 for a couple days which doesn't boost consistently. I've been driving 1/2 throttle and only about 15 psi and it still goes fast than stock
.
So far, the car is still not tuned and has a funky boost controller in place of the EVC 6 for a couple days which doesn't boost consistently. I've been driving 1/2 throttle and only about 15 psi and it still goes fast than stock
![lol](https://www.evolutionm.net/forums/images/smilies/lol.gif)