Finally trunk mounted my battery...
#31
Thread Starter
Evolved Member
iTrader: (37)
Joined: Sep 2003
Posts: 3,146
Likes: 2
From: Spec-Ops Motorsports, Fayetteville, NC
thanks... the battery tray we didnt make, just came up with our own mounting solution for it. Do a search on ebay for optima battery tray and look at all of the options out there... or go to summit racing, they have a nice one there as well. What i did with the tray was mounted above the floor by about a 1/4 of an inch. That way i could cut the carpet smaller than the tray so it would go under the tray and look cleaner.
#34
Thread Starter
Evolved Member
iTrader: (37)
Joined: Sep 2003
Posts: 3,146
Likes: 2
From: Spec-Ops Motorsports, Fayetteville, NC
its really not a kit... i picked up pretty much everything from ebay except for the battery. Pick whatever terminals you want to use... i chose one with a digital readout. I picked 18ft of 0 gauge wire (probably could/should have used 4 though) ... i picked up 2 stinger groud feet (only used 1), 2 stinger distro blocks (used 1).
Search criteria:
Ground feet
Ground distribution
optima battery tray
digital battery terminal
0 or 4 gauge wire
that was all i needed. Minus a few misc cables i had laying around to make lines longer or to change the run length or path. A fairly easy but time consuming process.
Search criteria:
Ground feet
Ground distribution
optima battery tray
digital battery terminal
0 or 4 gauge wire
that was all i needed. Minus a few misc cables i had laying around to make lines longer or to change the run length or path. A fairly easy but time consuming process.
#45
Thread Starter
Evolved Member
iTrader: (37)
Joined: Sep 2003
Posts: 3,146
Likes: 2
From: Spec-Ops Motorsports, Fayetteville, NC
Thanks fellas....
filter fits just fine actually, i just switched to the 4" intake so its a little shorter than the original 3" pipe. Soon the air box comes, so its a temp position.
Tray holds the battery pretty solid. At first i was a little worried because the battery didnt seem to drop down in the tray very much, but even without the clamps on it, she is pretty solid in the tray, after the clamps its even better.
Jamsky is definitely lost on this one
Rob, i should have your manifold and other stuff back in a couple weeks
filter fits just fine actually, i just switched to the 4" intake so its a little shorter than the original 3" pipe. Soon the air box comes, so its a temp position.
Tray holds the battery pretty solid. At first i was a little worried because the battery didnt seem to drop down in the tray very much, but even without the clamps on it, she is pretty solid in the tray, after the clamps its even better.
Jamsky is definitely lost on this one
Rob, i should have your manifold and other stuff back in a couple weeks