Progress pics of our custom widebody shop car...
#47
Former Vendor
Thread Starter
iTrader: (3)
Join Date: Jan 2004
Location: So. Cal.
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, its been quite a journey. That is the magnaflow ti exhaust. It is not staying on the car and has been adjusted since. We were working with RPS on their billet carbon clutch. We have tested, removed, made changes and reinstalled a few times. We just built another manifold. made 505 whp at 28 psi with load on the old manifold but had a boost creep problem and was laggy. It is a monster and we are just starting with the tuning. The CCWs used to be on our drag car but we are using them temporarily. here are some pics of our drag car:
We have 15" weld wheels. stock wheels are temp, as we made our own mini brake kit:
as you can see,we have a lot going on and it is hard to go back and forth and take care of customer cars at the same time.
thanks again.
Shahin
We have 15" weld wheels. stock wheels are temp, as we made our own mini brake kit:
as you can see,we have a lot going on and it is hard to go back and forth and take care of customer cars at the same time.
thanks again.
Shahin
#60
Former Sponsor
iTrader: (181)
Join Date: Jun 2007
Location: Glendale, CA
Posts: 2,681
Likes: 0
Received 0 Likes
on
0 Posts
The car is... well... Doing good, but the Hydra has to go. We're going back to the stock ECU w. an AcessPort. Hopefully that will last until AEM comes out with a better solution.