FastLearners Build Thread
Apr 6, 2010, 06:23 AM
#16
Evolving Member
Thread Starter
iTrader: (16)
Join Date: Jul 2007
Location: West Richland, WA
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
Was originally going to degree the cams, but these are the JUN 272 copies which were made by GSC and they have assured me they were dead on. Not that we didn't believe GSC, but Reid actually put the dial indicators on the cams to make sure after install they were to specs. I have been told JUNs are typically off up to 4 degrees or so since they are hand ground and not CNC'd. I'll update the info thread to reflect these are GSCs. Twin gates on a single scroll will hopefully allow for better boost control. Would a single 44 have been fine? Yes, but the twins sit so well in the space
Also have a few more of your trick parts going on the car as well I'm sure you'll easily recognize. Thanks STM for helping me w/ my build.
Apr 6, 2010, 09:41 AM
#22
looks very nice man but i have seen some of the other stuff you have not posted yet looking great man. Im glad you purpled matched everything I was going to do exactly that glad i did not as i dont want my bay to look like my buddies LOL. they whats going on with the exterior of the carwise i have seen your WIDEBODY Mazda
Looking good man!
Apr 6, 2010, 02:32 PM
#28
Evolving Member
Thread Starter
iTrader: (16)
Join Date: Jul 2007
Location: West Richland, WA
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
looks very nice man but i have seen some of the other stuff you have not posted yet looking great man. Im glad you purpled matched everything I was going to do exactly that glad i did not as i dont want my bay to look like my buddies LOL. they whats going on with the exterior of the carwise i have seen your WIDEBODY Mazda
