My Evo IX MR with RPF1's (18x9.5 +15)
Sep 17, 2010 | 12:08 AM
#34
u should of got these lugnuts they match the valve stem a lot better http://www.evasivemotorsports.com/me...tegory_Code=L1
Sep 17, 2010 | 03:05 AM
#37
Newbie
Joined: Nov 2008
Posts: 39
Likes: 0
From: nv
i almost have the same set up you do except i have nt03's 18x9.5+27 with of course the 10mm spacers and same tire size as well...my question is...do your front tires rub against the plastic by the sideskirts?
i ask cause mine do
i ask cause mine do
Sep 17, 2010 | 01:01 PM
#39
Thread Starter
Evolved Member
iTrader: (15)
Joined: Jan 2006
Posts: 854
Likes: 2
From: Long Island, New York
u should of got these lugnuts they match the valve stem a lot better http://www.evasivemotorsports.com/me...tegory_Code=L1
Thanks for the suggestion! Sick!
BRO I LOVE THESE! hahah
Sep 19, 2010 | 10:18 PM
#45
Thats in order for the spring along with a set of JDM MR Tails.
Thank you sir!
Thanks!
yeah def a little lower then a spring setup, but not by to much. The biggest need for the coilovers for this setup though is the camber adjustment and damper. I also am running a bit of a taller tire, so yeah. I still rub a little in the rear and sometimes up front is the bumps are good enough. Nothing serious though.
Thank you sir!
Thanks!
yeah def a little lower then a spring setup, but not by to much. The biggest need for the coilovers for this setup though is the camber adjustment and damper. I also am running a bit of a taller tire, so yeah. I still rub a little in the rear and sometimes up front is the bumps are good enough. Nothing serious though.
Just for curious sake, would it be necessary for rear rolling or pulling on the bilstein and swift spec r's?
