New headunit/hvac set up!
#185
The plate attaches like the original bezel, just 2 screws. I used two smaller screw to make it fit a little easier. The plate sandwiches the MR cubby between the climate control and plate. the second plate just attaches with some 3M sticky tape. It just covers up the edge of the temp, mode, and blower speed stickers. It's really simple.
#186
Evolving Member
iTrader: (11)
The plate attaches like the original bezel, just 2 screws. I used two smaller screw to make it fit a little easier. The plate sandwiches the MR cubby between the climate control and plate. the second plate just attaches with some 3M sticky tape. It just covers up the edge of the temp, mode, and blower speed stickers. It's really simple.
#187
Honestly there isn't much of a noticeable difference with or with out the second plate. I just put it on because I still had it. I didn't really think that the two screws was enough to support the climate control but it's actually pretty sturdy.
#191
I bought one of these. They are awesome. I will load a better picture of the actual kit during the day, but I've had it installed for 3 months now. One thing though my hvac lights don't work on one side and some times not at all. Anyone see that before? Ima check the bulbs I just never got around to it.
#192
Evolving Member
iTrader: (4)
I bought one of these. They are awesome. I will load a better picture of the actual kit during the day, but I've had it installed for 3 months now. One thing though my hvac lights don't work on one side and some times not at all. Anyone see that before? Ima check the bulbs I just never got around to it.
If all fuses are good, then you'll need to test by swapping the working bulbs to the non working side.
Hope this helps.
#193
How can I buy 1 of those relocation kits I want to instal a 2din in my Evo 8 but I need 1 of those relocation kits like the 1 above looks real clean where can I get my hands on 1