MuslimEvoFreak

iTrader: (39)

They do it for weight distribution.

4G63kevin

iTrader: (16)

delete post. found what i was looking for.

EmminoDaGreaT

Only thing I would do is cut the excess threaded rod off, and tape up the connection a little better ( if you haven't already done these)

phi79

iTrader: (6)

Very nice, this will go on my to do list.

MinusPrevious

iTrader: (3)

No Kidding. I was trying to be subtle. BTW, Your going down the wrong road

SCREAM8

iTrader: (5)

I did the same thing in my previous EVO. I don't have any pictures of the wiring being re-ran through the fender and the fuse set up before I got rid of the car though. I didn't want to have a bare trunk so I left the carpet.

CF03MR

iTrader: (1)

clean install. love the battery box. did this last year but used heavier cable and didnt use a battery box. i also made a bracket where the battery use to be and mounted my fuse link, catch can, and FPR on it. heres a couple pics

mmmmbst

iTrader: (6)

If you want the engine bay to look cleaner, theres a plastic tab on the left side of the fuse box on the firewall side. Drill a hole in it and mount a threaded bolt and mount the wires to it directly and secure with a nut. Very clean install BTW.

B.J.@ToxicFab

iTrader: (26)

Looks good but as others said the battery should be mounted on the right side as the left rear is heavier.

armympjch

iTrader: (10)

Thanks for the complients and suggestions. It didnt really cross my mind to place it on passenger side for weight distribution. All the pics that I seen on here had theirs on the driver side or centered. So I may switch it over there. And yes I did cut down the threaded bolts. I know for sure I will switch to 2 guage wire soon. But for some reason after moving my battery to the trunk, my car only boost 18psi.... So now I have to find out why my car is only boosting 18psi now. Seems like its always something. haha.

ebramisag

iTrader: (1)

how much for the batt?

Chaz17

iTrader: (11)

nice looking job. real clean. thinking of doing the same soon.

Pirana

iTrader: (43)

any pics on this

PatricksEvilEvo

iTrader: (12)

OP. What did you connect the negative to? I bought 2 gauge wiring and I'm having my buddy make me an aluminum box for it. I've been told the only place to get a real good ground is the block but I'd rather just run it down to my frame or trunk floor. What worked for you?

limp_noodle

iTrader: (29)

Ground it anywhere to the chassis, just make sure its metal to metal contact (remove all of the paint). I grounded mine to the threads where the RS trunk bar would have mounted to.