HELP! Powder coat brembo failure!

Reply Subscribe

Thread Tools

Search this Thread

May 31, 2007 | 12:22 PM

#16

cfdfireman1

Evolved Member

iTrader: (11)

Joined: Oct 2005

Posts: 4,165

Likes: 0

From: Chicago

for sale

search in the for sale section a lot of people are selling these.

Last edited by cfdfireman1; Jun 1, 2007 at 10:02 AM. Reason: link not working

Reply Like

May 31, 2007 | 12:36 PM

#17

Dinothegreat

Evolving Member

iTrader: (2)

Joined: Nov 2006

Posts: 238

Likes: 0

From: Cave Creek, AZ

Quote:

Originally Posted by KOM88

not at even close to the feedback i was looking for. but thanks for the idea? duct tape didnt do its job because the inside of the pistons are pitted and the surfaces that had zero tolerance, the matting side is completly pitted and blasted. 3 out of 8 surfaces had overspary around the edges the othe 5 were completley blasted.

You are going to have to take them to court to get it covered. They will argue that you asked them to do it and you were not specific enough about what you needed done. Do you have anything in writing?

Reply Like

May 31, 2007 | 12:43 PM

#18

DRFTKNGG

Evolved Member

iTrader: (8)

Joined: Aug 2004

Posts: 1,073

Likes: 0

From: FLORIDA

Quote:

Originally Posted by jhanksevo

Hey man hope you know brembo doesnt recommend them to be powdercoated only painted. I talk to a rep and thats what he told me so i had them painted

Correct. Low temp powder coat only.

Reply Like

May 31, 2007 | 12:54 PM

#19

DRFTKNGG

Evolved Member

iTrader: (8)

Joined: Aug 2004

Posts: 1,073

Likes: 0

From: FLORIDA

Ok...so take a straight edge across the mating surface and check if the surface is still flat. A piece of glass works best for this. As long as the surface is completely flat you should be ok. I have refinished a few calipers now and I dont break them down completely. It's not necessary. A high quality clear coat like Dupont's Chroma Clear will outlast the car!