SAI help
#1
Newbie
Thread Starter
iTrader: (1)
Join Date: Apr 2011
Location: wa
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
SAI help
I just got my alignment done and everything is ok except my front sai are off.. Last time i went to get an alignment the sai is in specs. Today my right side .4 lower and my left side is 3.8 lower than specs.. What could of caused it and what should i do to fix it... Thanks guys
Trending Topics
#10
Evolved Member
Did you install springs? or Was there something removed and installed before the alignment.
What was the reason to get an alignment?
Did you hit a curb or pothole?
If you did hit something, usually the strut bends first, then lower control arm, then knuckle.
What was the reason to get an alignment?
Did you hit a curb or pothole?
If you did hit something, usually the strut bends first, then lower control arm, then knuckle.
#13
Evolved Member
iTrader: (1)
I don't understand why you have a "before" and "after" alignment. Since each print-out has a before and after (labeled "actual"), I assume these are from two different trips to the shop, yes? If so, what happened between them?
And why did they leave you with so much toe-in at the left rear? Did you ask for zero toe and they couldn't do it or did you not specify any particular values as a target?
And why did they leave you with so much toe-in at the left rear? Did you ask for zero toe and they couldn't do it or did you not specify any particular values as a target?