front bracing with br race fmic
Jan 2, 2015, 08:21 AM
#1
Evolved Member
Thread Starter
iTrader: (10)
Join Date: Feb 2008
Location: the moon
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
front bracing with br race fmic
Does anyone know if cusco or any of the other front end braces will fit with a bus church racing fmic? I remember years ago hearing that most didn't fit....any input would help. Thank you.
Jan 2, 2015, 08:27 AM
#2
This is your best bet:
http://www.streettunedmotorsports.co..._crash_bar.htm
Says it'll fit over the Buschur Race Intercooler. Not sure what your goal is by adding a brace in front whether it'd be adding chassis stiffness or just a little bit of piece of mind over not having a crash beam but I'm sure STM's piece is well made and while it wont have as much strength over the factory piece its still better than nothing.
http://www.streettunedmotorsports.co..._crash_bar.htm
Says it'll fit over the Buschur Race Intercooler. Not sure what your goal is by adding a brace in front whether it'd be adding chassis stiffness or just a little bit of piece of mind over not having a crash beam but I'm sure STM's piece is well made and while it wont have as much strength over the factory piece its still better than nothing.
Jan 2, 2015, 08:31 AM
#3
Evolved Member
Thread Starter
iTrader: (10)
Join Date: Feb 2008
Location: the moon
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
Im after chassis stiffness as I never drive the car on the street, only track really. The part emery puts out is more of a piece of mind rather than chassis stiffness. I was looking at cusco but I'm almost certain curt brown mentioned that it didn't fit. This was, however, 4 years ago or so. Just trying to see if anyone else has experience with this.
Thread
Thread Starter
Forum
Replies
Last Post
PDXRalliArt
Lancer Vendor Classifieds
85
Jan 23, 2007 03:52 PM