Greddy Infometer Touch
#20
Evolved Member
iTrader: (12)
I had this installed since I brought one back from Japan back in May. I recently hardwire the power supply from behind the cig power leads. It's easy to tap and route from there to the cable. Just make a Y cable and tap the lead. Here is a short video I made a while ago of it in action. And yes the ECU boost reads 22.3 psi max on this device but I'm sure the optional sensors can read beyond that. Also I heard from a person in the EvoXforums that he was able to wire his AEM UEGO into the Greddy Informeter via serial +-5v wire connection supplied on the Greddy Informeter cables. I'm planning to wire my AEM boost gauge and UEGO into the Greddy Informeter. Will update when I get it done.
http://www.youtube.com/watch?v=2kmsw-2BDNo
http://www.youtube.com/watch?v=2kmsw-2BDNo
#21
Hey guys, after playing with it more I found that the boost output of the CAN interface is 22.3psi.... It's weird but it just pegs at 22.3psi. Luckily, I ordered the boost, oil pressure, and oil temp sensors too. I installed the boost sensor and it's reading great now. I just drove it around the block and noticed that it's showing boost peaks of 27psi. My tuning session showed 24.9psi logged via EVOScan and the mod23 patch. I'm going to continue to see if it's a difference between the ECU output and the vacuum sensor OR, if it's the drastic difference in temps between when I got tuned (90+ degrees) and today's temperature of 70 degrees while taking it for a test drive post-install. The oil sensors I'm going to install later at my next oil change (Bought the sandwich adapter). I'll try and get some pics tomorrow while the sun's out so stay tuned!
#22
I had this installed since I brought one back from Japan back in May. I recently hardwire the power supply from behind the cig power leads. It's easy to tap and route from there to the cable. Just make a Y cable and tap the lead. Here is a short video I made a while ago of it in action. And yes the ECU boost reads 22.3 psi max on this device but I'm sure the optional sensors can read beyond that. Also I heard from a person in the EvoXforums that he was able to wire his AEM UEGO into the Greddy Informeter via serial +-5v wire connection supplied on the Greddy Informeter cables. I'm planning to wire my AEM boost gauge and UEGO into the Greddy Informeter. Will update when I get it done.
http://www.youtube.com/watch?v=2kmsw-2BDNo
http://www.youtube.com/watch?v=2kmsw-2BDNo
#24
Infometer boost sensor adapter
sic was also saying the same thing about this & he's using jdm from the looks of it i have to get the sensor adapter & external boost sensor for the infometer.
#27
Evolving Member
Join Date: May 2009
Location: Davie, Florida
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
so let just get this straight, everything like the rpm waning and what not will work as long as its plugged into the ecu thing under the steering wheel?
#29
I acquired this week Greddy Informeter Touch.
Everything works but I have a problem, there is a delay between the motor rpm for example and the rpm shown on the greddy.
Is there a solution or not?
Thank you very much from switzerland.
Everything works but I have a problem, there is a delay between the motor rpm for example and the rpm shown on the greddy.
Is there a solution or not?
Thank you very much from switzerland.