RRE ECUtek - 355whp 349 tqe
#24
Newbie
iTrader: (1)
Join Date: May 2008
Location: UCF Orlando, FL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
I hope that exhuast sounds as good as it looks. Its really clean, and seems that RRE did a really clean job, I hope these products will someday be on the market.
They have the stock BOV venting to atmosphere though? Maybe I just can't see it.
They have the stock BOV venting to atmosphere though? Maybe I just can't see it.
#25
Evolved Member
Join Date: Feb 2008
Location: Rhode Island
Posts: 1,571
Likes: 0
Received 0 Likes
on
0 Posts
Ok guys... so the results are posted.
Please keep the "well it reads to high/low" well Buschur reads this, and AMS reads that comments to a min.
Getting the boost to work with the ECUtek is a pain in the ***.
Mivec settings were NOT touched.
it is on 91 octane, no fuel additives were used.
stock pump/injectors
Here is the mods list:
RRE - 3" Custom Intake
RRE - 3" Custom Lower Intercooler Pipe (cold pipe)
RRE - 2.5" Custom Upper Intercooler Pipe (hot pipe)
RRE - 3" Custom FMIC
RRE - 3" Test Pipe w/ Resonator and CEL Fix
RRE - 3" Exhaust w/ 3 resonators no muffler
ECUtek Boost Control set to 22psi , spikes to 24psi for a little bit
^^^ whp/tqe
^^^ Boost
^^^ Stock vs Tuned
Thanks for looking.
-Chris
Please keep the "well it reads to high/low" well Buschur reads this, and AMS reads that comments to a min.
Getting the boost to work with the ECUtek is a pain in the ***.
Mivec settings were NOT touched.
it is on 91 octane, no fuel additives were used.
stock pump/injectors
Here is the mods list:
RRE - 3" Custom Intake
RRE - 3" Custom Lower Intercooler Pipe (cold pipe)
RRE - 2.5" Custom Upper Intercooler Pipe (hot pipe)
RRE - 3" Custom FMIC
RRE - 3" Test Pipe w/ Resonator and CEL Fix
RRE - 3" Exhaust w/ 3 resonators no muffler
ECUtek Boost Control set to 22psi , spikes to 24psi for a little bit
^^^ whp/tqe
^^^ Boost
^^^ Stock vs Tuned
Thanks for looking.
-Chris
Last edited by KPerez; May 10, 2008 at 09:48 AM.
#27
Evolved Member
Thread Starter
iTrader: (10)
Join Date: Jan 2006
Location: CA
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
Injectors are maxed out, no logs as of right now, but they were in the high 90's.
Next set of mods are going to be 1000cc injectors and a fuel pump. Then re-tune with higher boost.
-Chris
Next set of mods are going to be 1000cc injectors and a fuel pump. Then re-tune with higher boost.
-Chris
#29
Evolved Member
Join Date: Jun 2007
Location: tsukuba turn 4
Posts: 846
Likes: 0
Received 0 Likes
on
0 Posts