Methanol injection?
#16
Evolving Member
iTrader: (2)
Join Date: Feb 2007
Location: Burbank, CA
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Agreed, fail-safes which can control boost (or other parameters) would still be needed. However, it would still be a nice option to have a separate, optimized gasoline tune in case you did not want to run meth for a while (like a long road trip).
#18
Evolving Member
iTrader: (2)
Join Date: Feb 2007
Location: Burbank, CA
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
You have alternate maps for the X?
Don't you still require some kind of failsafe mechanism as the trigger for the map to switch?
I'm new to meth/water injection and map-switching, just trying to understand the fundamentals.
Don't you still require some kind of failsafe mechanism as the trigger for the map to switch?
I'm new to meth/water injection and map-switching, just trying to understand the fundamentals.
#21
I was testing using the knock sensor input using some logic pieces and a relaywith the ground signal from the HSF6 to trip the map to the low octane maps which worked well. However the reset to high output map takes alot longer than desired and the knock learn takes even longer to reset. It was idea but what I would have called a failure. Although another thing learned about the ECU. i am curious what you have in mind I am waiting for one of the members to send me a dissassembly. I don't see why a pointer couldn't be used to redirect based on simple logic. Using a small loop with a jump. More time is needed.
#27
i run the aquamist system i also run the forge waistgate so my wg pressure is 17 to 18 psi
so my tunner tunned my car to wg pressure frist then has the meth turn on right around the wg pressure and finished tunning the only down side to this that i saw was when the meth turns on the power comes on hard so i tend to have traction issues
if i turn off the meth kit my car made 296 whp at 17 to 18 psi with the meth on i made 395 at 21 psi
i should be headed back to the tunner in a week or so to get tunned at 30 psi so we will see what new numbers i put down this was on a dynodynamics
so my tunner tunned my car to wg pressure frist then has the meth turn on right around the wg pressure and finished tunning the only down side to this that i saw was when the meth turns on the power comes on hard so i tend to have traction issues
if i turn off the meth kit my car made 296 whp at 17 to 18 psi with the meth on i made 395 at 21 psi
i should be headed back to the tunner in a week or so to get tunned at 30 psi so we will see what new numbers i put down this was on a dynodynamics
#28
Is E85 available where you're at? If not I think running dual maps would be best if you run either of them. Having a fail safe sounds like a necessity from what I've seen through my research. I just ended up going with E85 but I live down in San Antonio and we have quite a few stations.
Thread
Thread Starter
Forum
Replies
Last Post