Agency Power downpipe problems
#18
Evolved Member
iTrader: (33)
Join Date: Jul 2006
Location: 2 places
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
before tightning up the downpipe to o2 housing, you need to tightly bolt up the other end of the dp to the cat. then your dp should line up properly, last piece is to thighten the dp to o2 housing bolts
until then, dont (not u specifically) agency power products.
until then, dont (not u specifically) agency power products.
#19
Evolved Member
iTrader: (33)
Join Date: Jul 2006
Location: 2 places
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
before tightning up the downpipe to o2 housing, you need to tightly bolt up the other end of the dp to the cat. then your dp should line up properly, last piece is to thighten the dp to o2 housing bolts
until then, dont bash (not u specifically) agency power products.
until then, dont bash (not u specifically) agency power products.
Thread
Thread Starter
Forum
Replies
Last Post
2 Deep Motoring
Evo X Dyno Results
30
Dec 27, 2010 10:52 AM