ETS parts installed
#31
http://www.youtube.com/watch?v=OXLroe2eEFU
#32
^^ Please note, that this only applies to ETS parts.. and not necessarily someone else's.
The ETS intake utilizes the stock MAF housing, so no scaling on the ECU is required. Getting a tune is still a good idea, but I trust that Michael knows more about his parts than we do.
The ETS intake utilizes the stock MAF housing, so no scaling on the ECU is required. Getting a tune is still a good idea, but I trust that Michael knows more about his parts than we do.
Also, Michael says it is safe to run bolt ons on a stock tune. I assume this is because it is already running pig rich from the factory so a little extra air/flow will be ok. I however already had a custom tune before any mods to lean it out, IS IT STILL "SAFE"?
Last edited by DANNY08GSR; Jan 6, 2012 at 06:25 AM.
#33
AFD - Where is this orginal thread? I'd like to read it.
Also, Michael says it is safe to run bolt ons on a stock tune. I assume this is because it is already running pig rich from the factory so a little extra air/flow will be ok. I however already had a custom tune before any mods to lean it out, IS IT STILL "SAFE"?
Also, Michael says it is safe to run bolt ons on a stock tune. I assume this is because it is already running pig rich from the factory so a little extra air/flow will be ok. I however already had a custom tune before any mods to lean it out, IS IT STILL "SAFE"?
https://www.evolutionm.net/forums/ev...tock-tune.html
If you already have a tune though, that might be a different story.
#34
Rumor has it the backordered ets 4" fmic are not too far away. What is typical install time for this front mount? I'LL BE DOING IT MYSELF AND WAS WONDERING IF I COULD PUT IT IN THE NIGHT I GET IT OR SHOULD IT WAIT FOR A WEEKEND?
#36
You Sir Are Correct! We are building them this week
Thread
Thread Starter
Forum
Replies
Last Post
JReid
Evo X Dyno Results
12
May 6, 2011 07:44 AM
ETS Michael
ExtremeTurboSystems.com – WA
30
Nov 14, 2007 02:46 PM