How to configure the OEM navigation so it reads from aux input 8750A145?
#1
Evolved Member
Thread Starter
How to configure the OEM navigation so it reads from aux input 8750A145?
I recently installed a Mitsubishi OEM aux input 8750A145 to the console, and connected the navigation cable (connected to a dummy female connector behind the console from the factory) to the aux input. However, when I connect an RCA cable and my phone to the aux connector, the navigation does not recognize anything.
What did I do wrong? Should there be some configuration that needs to be done so the navigation can read from the RCA/aux input?
Thanks in advance.
By the way, I was following the instruction of this thread: https://www.evolutionm.net/forums/ev...on-bypass.html
What did I do wrong? Should there be some configuration that needs to be done so the navigation can read from the RCA/aux input?
Thanks in advance.
By the way, I was following the instruction of this thread: https://www.evolutionm.net/forums/ev...on-bypass.html
Thread
Thread Starter
Forum
Replies
Last Post
jchang
Evo X Electrical / Audio / Security
3
May 15, 2015 10:23 AM
#1deliveryboy
Lancer Audio and Security (All models)
2
Oct 19, 2006 09:56 AM
HoLeeRay
General Engine Management / Tuning Forum
11
Mar 2, 2005 12:56 PM