mounting the license plate
#92
hey guys..maybe you can try this on the evo x...mount it under the bumper and pull it out..it will look alot better than drilling the front of the bumper
http://www.swiftmotorsports.com/prod...f5daea5b033163
http://www.swiftmotorsports.com/prod...f5daea5b033163
#97
Evolving Member
iTrader: (9)
Join Date: Apr 2007
Location: In the Middle of Everywhere
Posts: 434
Likes: 0
Received 1 Like
on
1 Post
Just a little info on what I did . seem to work well and very quick to change.
I bought one of the cheap autozone universal lic plate and zipped tied it with 2 long zip tie end to end. very easy to get it behind the molding. very snug. over the front bumper. fit perfect in size only blocks a couple on inches on the bumper holes. seems so far to be the best location, looks good in the center rather than to one side.. mounts flush,
I bought one of the cheap autozone universal lic plate and zipped tied it with 2 long zip tie end to end. very easy to get it behind the molding. very snug. over the front bumper. fit perfect in size only blocks a couple on inches on the bumper holes. seems so far to be the best location, looks good in the center rather than to one side.. mounts flush,
#99
Evolved Member
iTrader: (2)
Join Date: Jul 2005
Location: Wisconsin
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
will double sided tape do the job? I was thinking about that but i feel like it would fall off. I wish there was some way It could be magnetic. Like I could just stick it to the front when i drove certain places and then just rip it off other times. I might install some sort of quick connect thing in the bumper that doesnt look to bad so I can take it on and off in a hurry
use the factory Mouunt but double stick tape it, or get sticky tape velco and velcro it on. keep it on the drivers side though as your oil cooler is on the passenger side
#101
Evolved Member
iTrader: (12)
I just created a How-to Guide for installing a mounting bracket to the bumper with tie straps. Go check it out.
https://www.evolutionm.net/forums/sh...d.php?t=355848
https://www.evolutionm.net/forums/sh...d.php?t=355848
#102
Evolved Member
iTrader: (7)
hey guys..maybe you can try this on the evo x...mount it under the bumper and pull it out..it will look alot better than drilling the front of the bumper
http://www.swiftmotorsports.com/prod...f5daea5b033163
http://www.swiftmotorsports.com/prod...f5daea5b033163
#104
Evolving Member
Join Date: Aug 2007
Location: New York
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
#105
Evolved Member
iTrader: (12)