imajinmyfx

iTrader: (8)

my fuses keep blowing. even when i change them they blow right in front of me... i can see it actually spark. .. its the fuse for the interior electronics

uranium9v

iTrader: (3)

What did you change? Something is wired wrong for the current to be constant like that.

ear60008

iTrader: (2)

Did You Put An Aftermarket Radio In?

imajinmyfx

iTrader: (8)

i didnt change anything (electrical wise) .. the only thing i did was remove my bumper so that i could sand a part down that i bondo'd... but i also adjusted my headlights so that my HIDs wouldnt point straight up and all i have to do was turn a lil' knob. .. i dunno whats up... i thought it was because i had my door open while i changed the fuse so i did it again only with my door closed but it still blew.... thanks for u help.

imajinmyfx

iTrader: (8)

yup. but its been in my car for about a yr and 3 months

KUlancer

got neons? your neons could be shorting out the interior fuse... (depends on wiring i guess.)

imajinmyfx

iTrader: (8)

nah .. i dont have neons.. it was working fine but then when i took off my bumper and put it back on it blew for some reason

timdog4life

iTrader: (10)

you have fog lights? or the jdm headlights, maybe one of the ground wires came loose? I'm not even sure if these would cause a short for the interior fuse but thats all I can think of. When I blew my interior fuse installing my headunit I noticed that one of my tail lights went out too....

imajinmyfx

iTrader: (8)

you could be right !!! .. i have the JDMs and i removed them so i could adjust the beam pattern and i was trying to figure out what wires where what. thanks i'll check it out if it was the ground wire

urbanknight

iTrader: (14)

aftermarket fog lights? aftermarket radio? HIDs? Sounds like you have some changed electrical parts to me. My first guess would be the HIDs, since they may or may not be running the same power. Any of those can havea short or bad connection, and until you fix it, the fuse will keep blowing because it's being overloaded with too many amps. That's what the fuse does, it is designed to blow at a lower amperage than the electronics it's connected to, so if you get too many amps, they won't damage your expensive electronics.

lookslikeanevo

iTrader: (23)

when i first got my HID's the fuses kept going on me also ...just make sure that no wires are exposed and that everything is grounded...what fuse keeps blowing?

Link286XT

iTrader: (3)

what fuse is blowing? that could help us =)

Link

Sentinal

Deff wireing whatever you changed fix it most likely something on the neg side of the fuse is getting grounded before it reaches the resistor (light or whatever) or something inside the component is grounding it.

imajinmyfx

iTrader: (8)

its the red 10 fuse. the one of the two thats in that little yellow box.... the one closest to the windshield is the that keeps blowing.

imajinmyfx

iTrader: (8)

did u change the fuses from 10 to 20 for ur HIDs? ..