*** UTEC Control Center release 3 available ***
#32
Evolving Member
Thread Starter
Join Date: Jun 2003
Location: SW PA
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BJai02
I've been using the UCC rel3 since I had my UTEC an dit's been working great! But all in a sudden, it starts to give me CHECKSUM ERROR for whatever map file I open. Even I created a new file from UCC and save it, I can't re-open it after I close it.
I tried to uninstall it and re-install from scatch and it does the same to me.
BigBoogieman, have you seen anything like that? Or is there a work around to fix teh Checksum Error problem? I can't even open the file that I download from my own UTEC now. And I don't want to be stuck with the HyperTerminal...
Thanks in advance for any advice!
I tried to uninstall it and re-install from scatch and it does the same to me.
BigBoogieman, have you seen anything like that? Or is there a work around to fix teh Checksum Error problem? I can't even open the file that I download from my own UTEC now. And I don't want to be stuck with the HyperTerminal...
Thanks in advance for any advice!
But it seems a little weirder than I thought, based on your description. Could you post a new map that you create that you're unable to load? I want to see if the problem is when it's saved or when it's loaded.
#33
Evolving Member
iTrader: (5)
Join Date: Feb 2004
Location: Bay Area
Posts: 354
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BigBoogieman
Could you post a new map that you create that you're unable to load? I want to see if the problem is when it's saved or when it's loaded.
Since inserting map didn't work, I had to start off with an old old map, then plugging in the numbers one by one all over again and then it worked. Now you mentioned, I remember I did some tweaking through Hyperterminal on the boost map before teh file was corrupted.
#34
Evolved Member
iTrader: (4)
Join Date: Apr 2004
Location: dirty jerz!
Posts: 684
Likes: 0
Received 0 Likes
on
0 Posts
i don't have a serial cable on this laptop and i bought a usb/serial cable. is there any way to configure UCC to work with the USB port or do i have to configure the usb cable to com1? if so, how do i do this is winxp pro? (it's actually tablet edition, but it's similar to pro)
#35
EvoM Guru
iTrader: (5)
You configure your "Serial cable" (your USB-Serial adapter) for whatever com port that works for you.. Probably Com1 or Com2 if its a tablet PC with no regular com port...
Nothing oyur going to use to work with the UTEC uses a USB cable natively, their all "Serial port" devices and software..
Nothing oyur going to use to work with the UTEC uses a USB cable natively, their all "Serial port" devices and software..
Thread
Thread Starter
Forum
Replies
Last Post
Spun Autosports
Evo 'For Sale' Engine Internals and Drivetrain
25
Jun 4, 2007 03:42 AM
201Motorsports
Evo Vendor 'Group Buy / Specials' Classifieds
12
Sep 30, 2006 09:09 AM
BigBoogieman
General Engine Management / Tuning Forum
15
Sep 7, 2004 08:41 PM
BigBoogieman
General Engine Management / Tuning Forum
29
Aug 26, 2004 07:34 PM