this has probably been covered before but thought i'd ask just to be sure .
i have an AEM ems on the way. my question is what other parts would a need to add for an maf delete since i've searched and theres no real maf delete kit out there. another question is what the difference between 3.5 bar and 5bar map sensor. i plan to run maybe 30 psi at the most which one would be best.
thanks for your time.

 

bump

 

Before I purchased mine, I read just about every single thread in the AEM EMS section. Its only 12 pages long and all this is in there.

I believe you will need the 3.5 bar sensor. Obviously the 5 bar will hold more boost. You will also need the IAT sensor. which is the intake are temp.

The AEM forum discusses wiring, location, benfits of 3.5-5 bar. Research and you will be enlightened.