My turbo set-up
#77
Evolved Member
iTrader: (4)
Join Date: Jan 2007
Location: Socal~ The Valley (818) <3
Posts: 1,457
Likes: 0
Received 0 Likes
on
0 Posts
Take her apart and make sure spring is set. Also, did the thing have a valve seat that went int between the wastegate and the pipe?
A guy here had that issue, and ended up selling the kit cuz he was retarded and couldn't figure out why he was slow
#78
Evolved Member
Thread Starter
iTrader: (8)
Join Date: Nov 2006
Location: New York
Posts: 797
Likes: 0
Received 0 Likes
on
0 Posts
As I recall, yes there was. I mean, I did pull good numbers through more then 10 pulls. Something happened after that, while cruzing home.
I'll open the top of the wastegate once I get home.
I'll open the top of the wastegate once I get home.
#87
Evolved Member
Thread Starter
iTrader: (8)
Join Date: Nov 2006
Location: New York
Posts: 797
Likes: 0
Received 0 Likes
on
0 Posts
BTW, here is the dyno sheet. Please don't mind the rpm. For some reason it showed wrong rpm. Tune was done all the way to 6800rpm. A/F is not showing but it's low 11s because of the high compression.
Torque could have been even higher but we pulled alot of timing.
Below are my old NA numbers, lol. I only gained more than 100 torque to the wheels, lol.
206/223
Torque could have been even higher but we pulled alot of timing.
Below are my old NA numbers, lol. I only gained more than 100 torque to the wheels, lol.
206/223