trouble with 1.3 tactrix cable
#17
Newbie
Thread Starter
Join Date: Jan 2009
Location: Dothan, AL
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
v1.29a did the same thing and i have to wait til after the first to get unlocker b/c its in RAR compression. If anyone has that unlocker without it being compressed or winzip or something let me know
#18
Evolved Member
iTrader: (20)
#19
Newbie
Thread Starter
Join Date: Jan 2009
Location: Dothan, AL
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
does the unlocker have to be with v1.29a or can it paired with 1.42 b/c i tired 1.42 and same thing happened so im at the point that this certain cable sucks
#23
Newbie
Thread Starter
Join Date: Jan 2009
Location: Dothan, AL
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
I downloaded v1.29a. Im gonna try again in the morning to flash ecu. Senate why does the maps for my rom change so much when i went to v1.29a from v1.42??? Its kinda like it was before kinda all jumbled up like before.
#26
Evolved Member
iTrader: (20)
After v1.29a, all the endian values were interpretted as "big" and not "little". With v1.29a and before, they were mixed. So if you open your ROM in a newer version of EcuFlash, the table data will look right, but the axis values will be jibberish. With the table open, you would go to Edit > Edit Map Definition. Then you would click the Scalings button and change the scaling (fuel tables use Load and RPM) for each axis. When the Scaling Manager opens up, find the axis in the list (Load and RPM for fuel tables) and click Edit. Then change the data endian value to "big". Now you will see the axis values showing up correctly. You will need to do this for Metadata of each table.
#28
Evolving Member
iTrader: (1)
Join Date: Sep 2004
Location: Abu Dhabi, UAE
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
i have the same problem of the original thread composer.
tried the unlocker. no good.
tried 1.3 and 2.0 cables no good.
tried 1.29 and 1.40 no good.
dont know what to do?
read is ok but write gives the error message!
tried the unlocker. no good.
tried 1.3 and 2.0 cables no good.
tried 1.29 and 1.40 no good.
dont know what to do?
read is ok but write gives the error message!
Thread
Thread Starter
Forum
Replies
Last Post