Crank Pulley for the 2.0 engine
#46
Former Sponsor
iTrader: (67)
Join Date: Dec 2001
Location: Santa Fe Springs, CA.
Posts: 7,826
Likes: 0
Received 3 Likes
on
3 Posts
We have prototype done. Before I produce it, i need to know how many of you are serious for getting one. Basically this is a balanced, lightened pulley. It is not underdrive but is only 1/4 the weight of a stock one. All CNC machined aluminum, and is is a direct bolt on!
ROAD/RACE
ROAD/RACE
#48
Former Sponsor
Thread Starter
iTrader: (133)
Join Date: Dec 2003
Location: Anywhere
Posts: 3,123
Likes: 0
Received 0 Likes
on
0 Posts
Looking hot! I am glad to see this getting going and thanks RRM for making it happen. I am sure this will make substanstial difference to the drivability characteristics. Good Luck to further speculation and sales.
#52
Former Sponsor
iTrader: (67)
Join Date: Dec 2001
Location: Santa Fe Springs, CA.
Posts: 7,826
Likes: 0
Received 3 Likes
on
3 Posts
We may want to make it if we get 20 preorders. Once the decision is made, it will only take about 2 weeks to get them done. Remember this will greatly improve throttle response and driveability of the engine. Peak h.p. will not be affected. It is going to be similar to a aluminum flywheel. Stock pulley weighs more than 4 lbs. This one weighs 1 lbs.
ROAD/RACE
ROAD/RACE
#56
Evolved Member
iTrader: (13)
Join Date: Mar 2003
Location: Chi-Town
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
is there a special price for being of the first to put in and get the production started?
please say yes Rob, i'm interested but I probably can vouch for a lot of peeps on here...I'M ON A TIGHT BUDGET! I'll be down, just want to see how much it would be first.
please say yes Rob, i'm interested but I probably can vouch for a lot of peeps on here...I'M ON A TIGHT BUDGET! I'll be down, just want to see how much it would be first.