Notices
Lancer General Come on in and discuss the US Lancer.

Engine Performance Part Review

Thread Tools
 
Search this Thread
 
Old Jan 12, 2006 | 08:08 AM
  #31  
oz4g94's Avatar
Evolved Member
iTrader: (3)
 
Joined: May 2005
Posts: 710
Likes: 0
From: Lawrenceville, GA
Megan racing short shifter
cheap and works!

DC sports tcs catback
sounds good, more lowend gains

kamikaze headers
fair gains throughout powerband(if you can even call it that )

Injen CAI
little to no gains, but looks cool

Apexi SAFC2
fair gains throughout, if tuned correctly

PLX m-250 w/ gauge
does what its supposed to

Kartboy exhaust hangers
a lot stiffer, but be ready to hear your dp rattle.

Brembo slot rotors & Axxis Ultimates
great brakes (lots of brakedust though).

Last edited by oz4g94; Jan 26, 2006 at 07:09 AM.
Old Jan 23, 2006 | 07:51 PM
  #32  
sykou's Avatar
Evolved Member
iTrader: (19)
 
Joined: Aug 2004
Posts: 1,078
Likes: 0
From: Hawaii
AEM CAI w/ bypass valve(prevent hydrolock) - . Good low to mid
(AEM claims dynoed 8hp). Deep throaty sound throughout powerband.

RRM Header - Fitment is perfect. Great mid to high end. Lose some low end/torque but its worth it. Little bit buzzy sound like a civic in mid to high end.

JIC Magic Bullet muffler w/ custom 2.25" piping. High end as with any wide open exhaust system. Lose some low-end/torque.
Old Jan 23, 2006 | 11:49 PM
  #33  
comatose721's Avatar
Evolved Member
iTrader: (16)
 
Joined: May 2004
Posts: 1,425
Likes: 2
From: Toms River, NJ
AEM UEGO GAUGE-TYPE CONTROLER W/ WIDEBAND - a bit pricey. does it's job though so i can't complain. controler/gauge is very nice though. super sturdy. not sure if it's worth the $$$ though

RRM CS Pulley - amazing. great bang for buck. rev's quick. improved throttle response. easy install

RRM SS Clutch Line - simple mod. little stiffer in the pedal. not much though. more accurate and consistant clutch engagement even after beating the crap out of the car. looks good and does its job. no complaints.
Old Jan 25, 2006 | 09:20 AM
  #34  
sthiewes's Avatar
Evolved Member
iTrader: (5)
 
Joined: Jul 2004
Posts: 659
Likes: 0
From: NJ
Originally Posted by comatose721
RRM CS Pulley - amazing. great bang for buck. rev's quick. improved throttle response. easy install
Just installed last night with Mark. I have to agree with him on this comment
Old Jan 25, 2006 | 10:43 AM
  #35  
Kurt's Avatar
EvoM Staff Alumni
iTrader: (1)
 
Joined: Jul 2002
Posts: 2,123
Likes: 1
From: Maryland.
NEX full coilovers The car handles great. I got mine for a great price.

Brembo Slotted Rotors and Axxis Ultimate Pads What a great breaking combo. The car stops much better than before.

RMR SRI This is being replaced with an Injen SRI because it does not fit under the RRM X-Bar

RRM X-Bar This has improved the handling of my car even more. Great buy

RRM Axel Back Sounds alright, no real gains. To be replace soon with a Greddy or Magnaflow catback.

GReddy Counter Weighted shift know I was not sure if I would notice any improvements, but shifts feel a little bit quicker. Can't wait for my B&M short shifter.
Old Jan 25, 2006 | 11:30 AM
  #36  
wiretap's Avatar
Evolved Member
iTrader: (2)
 
Joined: Apr 2004
Posts: 2,299
Likes: 1
From: Michigan
RRM non-IC T-25 Turbo Kit
Comes with everything you need.. looks awesome, performs like it should. Nearly doubles the whp of the lancer, so expect some pretty big gains. I haven't been dyno'd yet, but I should be around 200whp or so. (RRM Header, Test Pipe, Magnaflow Catback, lightened flywheel) I can hit the gas in any gear, and at about 2500 to 3000 rpms the boost and power really kicks in. The wastegate is pretty loud, but it can be recirculated back in if you don't like it. Made my 03 Lancer OZ Rally 5-speed quite a bit faster than my brother's 04 Ralliart 5-speed. In first gear if you floor it, there's just wheelspin after 3k rpm's if you don't know how to control it. You can really rip it into 2nd and launch the car forward... same with 3rd. (keep in mind I have stage 2 clutch though) 4th gear really pulls hard, and 5th gear is wayyyy better than without a turbo. 5th gear you can max out top speed no problem all the way to redline.
Old Jan 26, 2006 | 04:02 AM
  #37  
SocalES's Avatar
Evolving Member
 
Joined: Dec 2005
Posts: 342
Likes: 0
From: Corona, CA
ebay CAI - very nice throaty sound. best 25$ i have spent

custom catback - buddy gave me titanium muffler. had a local shop bend me a catback and put it all together. costed 90$ for the install. sounds great not annoying buzz or crackle. only crackle i get is on hard downshifts.

18x7.5 Maxxim Ahead wheels with 225/40/18 BFG g-force sports - too big for the car. need to sell them and get 17's. other than that, tires hook up very nicely especially after a smokey burnout

saving for the RRM IC turbo kit for 04-06 lancer and piggyback
Old Jan 26, 2006 | 07:06 AM
  #38  
oz4g94's Avatar
Evolved Member
iTrader: (3)
 
Joined: May 2005
Posts: 710
Likes: 0
From: Lawrenceville, GA
Originally Posted by Kurt
Brembo Slotted Rotors and Axxis Ultimate Pads What a great breaking combo. The car stops much better than before.
yes i will second that, just replaced mine with the same and it stops much better however, if you dont like loud brakes, then these are not the ones to get, when you apply the brakes with a reasonable touch, they will have a fairly loud humming sound (from the slots).
Old Jan 26, 2006 | 07:29 AM
  #39  
Kurt's Avatar
EvoM Staff Alumni
iTrader: (1)
 
Joined: Jul 2002
Posts: 2,123
Likes: 1
From: Maryland.
It goes away after a while, or I have got use to the hum. I kinda like the sound.
Old Feb 1, 2006 | 12:29 PM
  #40  
sthiewes's Avatar
Evolved Member
iTrader: (5)
 
Joined: Jul 2004
Posts: 659
Likes: 0
From: NJ
Anyone else like to share?
Old Feb 4, 2006 | 07:29 AM
  #41  
comatose721's Avatar
Evolved Member
iTrader: (16)
 
Joined: May 2004
Posts: 1,425
Likes: 2
From: Toms River, NJ
RRM "Big Red' Bored Fuel Rail - super easy to install, great price. noticed a little bit of throttle response. there's just that extra bit of fuel there when you need to romp on the pedal.

RRM Rear Motor Mount - a B*TCH to install!!! my knuckles are still aching. nice results once it is in though. there is a bit more vibration in the cabin but it is well worth it. no more wheel hop.....period.

DIY Front Motor Mount
- Simple, easy to do, used some Windo-Weld. very cheap. unfortunatly i had to repack the front mount a second time. was a little time consuming to bake the mount and let it sit before reinstalling it. if you plan on crafting your own i would recommend getting a second set and doing the job outside the car to achieve a full cure.
Old Mar 23, 2006 | 10:03 AM
  #42  
MIA2FASLANCER's Avatar
Newbie
 
Joined: Jan 2006
Posts: 98
Likes: 0
From: Miami
OK i know everyone is interested in buying performance parts for their Lancer
and the question always appears. will it work? is it going to be too loud?
is it worth it? can i get a better one? well here in this post im going to go over all my mods in detail so u can know so people can make thier mind... i know everyone says it depends on the mods well now u know these mods...
05 Lancer
Automatic
Miami
when i first got my lancer the first upgrade was

RRM Short Ram intake
for a great price u get a carbon fiber heat shield and a KnN Fileter
The Difference? Greater acceleration great Product!
18x7.5 inch Aerospeed Onyx Rims Black with Polished lip
the wider tires meant more base and the rims are pretty ligth so better acceleration and it improved sway
RRM Front Strut BarDefenetly improved the front handling less sway
RRM Headers
This took away some low end power but more Top end power
it wasnt loud it came ceramic coated very nice and at first u dont feel it
our ECU is slow but after the first day better performance
2.25 Custom Catback Greddy Exhaust with RRM resonator
makes an awesome sound not too loud not ricey at driving it sounds
great not too loud Thanks to the resonator at highway speeds is better in acceleration great product
at this point my car had pretty good acceleration and from a roll very good from STOCK
RRM Piggyback ECUthis is what made everything come together i gained a better low end
better pick up and better reaction. my third gear goes prettty quick
this was one of the best upgrades i made Greatest Product
Now it runs smoother faster and better
RRM Pulleyfaster revs better acceleration and reaction awesome
Magnacore Wires and NGK Iridum Spark Plugs
what this did to my car it gave it more stamina to get beaten up more
this mod made it everythihgn better by a bit not a huge difference but its noticeable
Back loe tie bar
this little mod gave me better handling little less oversteer
Conclusion after all these products i wouldnt buy others
RRM makes some pretty good stuff
my next mod is gonna be Magnaflow Highflow Cat
RRM Intake manifold Boreout
RRM Throttle Body
The more i Mod the more i will Put so far so good and RRM keep on making good products
Does anyone have intake mani n throtle body from RRM
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
DrivelineSales
EvoX 'For Sale' Miscellaneous
32
Sep 9, 2008 05:36 PM
mitsuboost30
Vendor Service / Parts / Tuning Review
15
Jun 15, 2008 12:21 PM
thestereogod
Mid-Atlantic Region
9
Mar 13, 2008 03:51 PM
outlaws69
Northwest Region
14
Oct 22, 2007 01:45 PM
Jakeg97
Future Lancer / Evo Models
15
May 13, 2005 11:30 AM




All times are GMT -7. The time now is 09:21 PM.