Lancer OZ with Evo Exterior + 4g63T+RWD
May 2, 2009, 03:06 PM
#121
Another update!
Got my custom bellhousing in a while back now, but progress has started on the supra gearbox. Photos show supra tranny with old bellhousing then with the new bellhousing install and finally bolted up to an old engine for mock up purposes. Enjoy!
Got my custom bellhousing in a while back now, but progress has started on the supra gearbox. Photos show supra tranny with old bellhousing then with the new bellhousing install and finally bolted up to an old engine for mock up purposes. Enjoy!
May 2, 2009, 07:32 PM
#123
Yes it will need a tunnel fabricated. Now that its mounted to the block, were going to measure and mock everything up. The front subframe will need to be cut in half, and a custom steering rack will need to be fabricated. The firewall will also be cut open as will part of the floor. The transmission tunnel will be built around the engine and transmission sitting in place in the car.
May 4, 2009, 07:41 AM
#131
The whole engine if from a 1st gen but it will be rebuilt for probably around 600hp and cost less then a evo long block. Like I said the bellhosuing guy probably wont have the evo block bellhousing's done until next year anyway.
