Replaced my carbon fiber gauge cups with an Autometer dual gauge steering column pod.

Before...

 

After...

 

looks better

 

There was one on EBay that had the guages part of the gauge bezel. They were more on the corners below the "Lancer" one on the right, and the tach on the left. I was kinda hesitant on getting it because I wasn't sure if it would cover up the tach too much. Lemme see if i can find it...

 

Here it is...

 

Looks good mcbrown, very clean looking I like it

 

Thanks! Great to see another Turbo Kam OZ out there!

 

i got one too, but how did you secure it? it doesnt have any clips like the oem piece....
?

BUDLoNG

 

looks good...

 

You got the OZ sticker on your cluster to make sure you never forget your trim level? Haha, just kidding, dont like the sticker but the guages look good.

 

^ i think it will look better without it

 

I have no cats so the check engine light is always on. It is bright as hell and hurts my eyes at night. Only reason the sticker is there..anyone know where to get the mil eliminator? There was a guy on here but he doesn't respond...

 

You do realize it fits over the stock piece, not a replacement... 2 small plastic screws (4 were supplied) you can see one in the second pic above...

 

AFTER looks way better and cleaner than BEFORE!!!!!!!!

-jbogs

 

Haha, after I wrote my reply I thought to myself "The onyl logical reason, If hes not a ricer, why he would put the sticker there is to block a CEL..." LOL, I would have gone with some black tape, but hey, you got some style points there.