Car Stutters during take off, almost no power... picks up when u floor it.
#47
Evolved Member
iTrader: (18)
Join Date: Jul 2003
Location: Jackson, CA (NorCal, Sacramento)
Posts: 946
Likes: 0
Received 0 Likes
on
0 Posts
yes, on the intake pipe. buy a can of MAF cleaner at any auto store for like $4. spray it all over the honey comb and sensor itself. probably wont fix the problem but will do more good than harm.
#55
Newbie
Thread Starter
iTrader: (2)
Join Date: Mar 2003
Location: Phoenix, AZ
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
How difficult is this thing to change? Like I've mentioned - when it comes to pistons I don't know jack.. however, if the Lancer had a rotary engine then I'd be all over it =P
#59
Evolved Member
iTrader: (8)
Join Date: Nov 2006
Location: New York
Posts: 797
Likes: 0
Received 0 Likes
on
0 Posts
People it's not the crank sensor that's wrong. It's cam angle sensor that's located on the head. I had the same problem. Trust me.
P.S. If anybody want a perfect working cas, send me a pm.
P.S. If anybody want a perfect working cas, send me a pm.
#60
Evolving Member
iTrader: (3)
Join Date: May 2004
Location: Missouri
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
I think where everyone's getting confused is the fact that there is no cam angle sensor per say. Mitsubishi calls it a cam position sensor, which from what you say is what needs to be replaced (P'Med you about that sensor, by the way). CAS is the acronym for the crank angle sensor.