wiper arm switch
Nov 27, 2003, 12:16 PM
#1
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Nov 2003
Location: Brunswick,ME
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
wiper arm switch
when i switch from full/slow to delay (slow or high), my wipers stay in the full slow mode. is this a common problem? does anyone else have a similar problem?
Nov 27, 2003, 12:49 PM
#2
The fastest delay setting is actually the same as full/slow if you are moving faster than about 40 mph. One of the coolest features Karlen told me about on our Lancers. The fastest delay setting actually adjusts its speed according to your driving speed!
Nov 28, 2003, 12:05 PM
#4
Evolving Member
Thread Starter
iTrader: (1)
Join Date: Nov 2003
Location: Brunswick,ME
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
it is raining to day so i had a chance to check this out.........
while the intermittent setting was in low, but the switch arm itself was in normal everything fine
when i switched it to the intermittent Low setting it stayed in the normal mode until I tapped on the end of the arm.
is this switch defective?
while the intermittent setting was in low, but the switch arm itself was in normal everything fine
when i switched it to the intermittent Low setting it stayed in the normal mode until I tapped on the end of the arm.
is this switch defective?
Thread
Thread Starter
Forum
Replies
Last Post
kmcconn9
Lancer How To Requests / Questions / Tips
0
Nov 5, 2015 08:58 AM
