My RB26 Z32
#1
Evolving Member
Thread Starter
iTrader: (15)
Join Date: Oct 2005
Location: Peoria, IL
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
My RB26 Z32
Guys
I've owned this car for ~5 years, had an evo for the most part of 2005 and some of 2006 but sold it when I bought my house. This has been my lifelong project
The car put down 485rwhp @ an easy 14 psi on pump gas. I should be able to go ~18psi on pump gas, however I was tired of spending all day on the dyno and somewhat hungover. I'll probably get back to it sometime in the next few weeks to turn it up, and maybe do some race gas
Mods
RB26DETT/Trans/Harness
Z32 Transmission
Modified Cross Member
Custom Motor Mounts
Full-Race Manifold
T4 Twin Scroll Gasket
4 Studs/Nuts/Washers for Turbo
RB25 Modified Oil Pan
(2) Tial 44mm Wastegates
Tial 50mm BOV
Greddy Cam Gears
ARP Head Studs
Tomei 5 Layer Gasket Kit
Garret GT42
JGY Fuel Rail
TMS 1000CC Injectors
AEM EMS w/sensors
AEM UEGO
RB25 Slave Cylinder
Clutch Pivot Ball & Clutch Line
Greddy T-Belt
Timing Belt Pulley & Tensioner
N1 Water Pump
N1 Oil Pump
XS Engineering 4" FMIC
Custom Aluminum IC Piping
Clamps & Couplers for IC Piping
Crank Collar
Tomei Cams
Pauter Rods
CP Pistons
ACL Race Bearings
Flanges, Adapters, Clamps for Exhaust
4" Downpipe & Test Pipe Fab
Earls Fittings/Braided Lines For Fuel
Earls Fittings/Braided Lines For Oil
(2) 10" Permacool HD Electric Fans
Custom Double-Pass Radiator
Powertrix HICAS Eliminator Bar
AeroMotive FPR
Vids
I am not sure if the Mic was having problems or what but there is a little crackling in some of the vids, so dont interpret the cracking as the car stuttering, its definately the camera!
http://www.booztd3.com/Videos/RB26_4...Dyno_Front.wmv
http://www.booztd3.com/Videos/RB26_4..._Dyno_Rear.wmv
http://www.booztd3.com/Videos/RB26_4..._Dyno_Side.wmv
http://www.booztd3.com/Videos/RB26_480rwhp_Dyno_Top.wmv
http://www.booztd3.com/Videos/RB26_4...Dyno_Turbo.wmv
Peace Guys
I've owned this car for ~5 years, had an evo for the most part of 2005 and some of 2006 but sold it when I bought my house. This has been my lifelong project
The car put down 485rwhp @ an easy 14 psi on pump gas. I should be able to go ~18psi on pump gas, however I was tired of spending all day on the dyno and somewhat hungover. I'll probably get back to it sometime in the next few weeks to turn it up, and maybe do some race gas
Mods
RB26DETT/Trans/Harness
Z32 Transmission
Modified Cross Member
Custom Motor Mounts
Full-Race Manifold
T4 Twin Scroll Gasket
4 Studs/Nuts/Washers for Turbo
RB25 Modified Oil Pan
(2) Tial 44mm Wastegates
Tial 50mm BOV
Greddy Cam Gears
ARP Head Studs
Tomei 5 Layer Gasket Kit
Garret GT42
JGY Fuel Rail
TMS 1000CC Injectors
AEM EMS w/sensors
AEM UEGO
RB25 Slave Cylinder
Clutch Pivot Ball & Clutch Line
Greddy T-Belt
Timing Belt Pulley & Tensioner
N1 Water Pump
N1 Oil Pump
XS Engineering 4" FMIC
Custom Aluminum IC Piping
Clamps & Couplers for IC Piping
Crank Collar
Tomei Cams
Pauter Rods
CP Pistons
ACL Race Bearings
Flanges, Adapters, Clamps for Exhaust
4" Downpipe & Test Pipe Fab
Earls Fittings/Braided Lines For Fuel
Earls Fittings/Braided Lines For Oil
(2) 10" Permacool HD Electric Fans
Custom Double-Pass Radiator
Powertrix HICAS Eliminator Bar
AeroMotive FPR
Vids
I am not sure if the Mic was having problems or what but there is a little crackling in some of the vids, so dont interpret the cracking as the car stuttering, its definately the camera!
http://www.booztd3.com/Videos/RB26_4...Dyno_Front.wmv
http://www.booztd3.com/Videos/RB26_4..._Dyno_Rear.wmv
http://www.booztd3.com/Videos/RB26_4..._Dyno_Side.wmv
http://www.booztd3.com/Videos/RB26_480rwhp_Dyno_Top.wmv
http://www.booztd3.com/Videos/RB26_4...Dyno_Turbo.wmv
Peace Guys