Spec-Ops Motorsports Tune Day in Fairfax, VA on February 26th
Feb 15, 2011, 09:26 PM
#91
[quote=Jason@Spec-Ops;9078628]You wont need it for the tune... but if you need one, we can set you up. PM details for your wideband.
Sounds good, just wanna make sure the car is ready!
Sounds good, just wanna make sure the car is ready!
Feb 16, 2011, 11:17 AM
#92
I cant stress enough...
Leak test Leak Test LEAK TEST !!!
New plugs, gapped correctly, oil change if needed, parts installed and verified, make sure the car is in a good running order. If all that is good.... then the tune will go great. If we are forced to troubleshoot then it changes things.
Leak test Leak Test LEAK TEST !!!
New plugs, gapped correctly, oil change if needed, parts installed and verified, make sure the car is in a good running order. If all that is good.... then the tune will go great. If we are forced to troubleshoot then it changes things.
Feb 22, 2011, 06:00 PM
#96
Evolving Member
iTrader: (4)
Join Date: Jan 2010
Location: Enfield, CT
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
Finally got my bumper back on after I put on my new intercooler.. Gotta adjust the screen mesh where the intercooler is though... Hoping I can finish it up tomorrow.. I did a run to see if anything was leaking, held boost so no problems with my current setup. Let's hope it holds up.
Feb 22, 2011, 07:07 PM
#97
Finally got my bumper back on after I put on my new intercooler.. Gotta adjust the screen mesh where the intercooler is though... Hoping I can finish it up tomorrow.. I did a run to see if anything was leaking, held boost so no problems with my current setup. Let's hope it holds up.
Feb 23, 2011, 05:45 AM
#100
Evolving Member
iTrader: (4)
Join Date: Jan 2010
Location: Enfield, CT
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
The bumper won't go on because of a peice of metal hitting the intercooler and I can't rip it off with pliers. Think it would be ok not to have it on when you dyno it? The mesh piece will be in the car if you have any free time or ask keenan if he can cut the metal piece off.. I can epoxy it back on, the bottom part of the mesh on the bumper screws in.
