Lets see your "Work Space" #ShopJealousy
#76
Evolving Member
iTrader: (1)
As far as cracks, my concrete guy used inlaid plastic expansion joints and then trowelled over them. Small surface crack but it will be invisible once I get it epoxied.
I finally had electrical done in my garage. Had a 100 amp service brought into a separate breaker panel in the garage, several outlets, as well as 220v outlets. And an exterior breaker for the minisplit I just ordered.
Went with 18k BTU 21 SEER Hyper Heat Mitsubishi unit. More expensive than Chinese brands but call it a political expense.
Was gonna order maxjax but I see Danmar raised the price SIGNIFICANTLY...
I finally had electrical done in my garage. Had a 100 amp service brought into a separate breaker panel in the garage, several outlets, as well as 220v outlets. And an exterior breaker for the minisplit I just ordered.
Went with 18k BTU 21 SEER Hyper Heat Mitsubishi unit. More expensive than Chinese brands but call it a political expense.
Was gonna order maxjax but I see Danmar raised the price SIGNIFICANTLY...
that kind of electric.
The following users liked this post:
ViciousLSD (Dec 1, 2021)
#80
Evolving Member
iTrader: (1)
It's likely you just didn't notice the control joints but if there really were in fact no control joints then there will for sure be cracking. It's possible that the joints were skimmed over with a topping slab or sealer.
Thread
Thread Starter
Forum
Replies
Last Post