Sup w/them 2024 Fall Projects?
#3137
#3141
#3142
i wouldnt be surprised if the wiring was there even in the loom. just not plugged up.
You can buy flexible braided line kits for them or just make your own. the factory line is a hard line that runs along the loom where the brake lines run
You can buy flexible braided line kits for them or just make your own. the factory line is a hard line that runs along the loom where the brake lines run
#3143
It would make sense to use the same harness, but I haven't seen anything like that back there. That would be too easy.
#3144
If I saw the right link, the kit is for the JDM/EUDM cars which have the pump in the.. so you need to make your own lines anyhow..
#3145
Unfortunately it's not there. I did look hopefully lol. Only way is to extend the harness from the engine harness up front.
#3146
#3147
#3148
I found the best option to be just cutting the existing line and putting a hose on it with double clamps. I know the pump says it can make some crazy pressure but Ive never logged more than 90psi.
The following users liked this post:
kaj (May 26, 2021)
#3150
Can always use a flare tool to flare the line as well, give the clamp something (a "barb") to butt up against.